KITO ER2 Serie Manuel Du Propriétaire page 33

• Do not use the Friction Clutch to measure the weight of a load.
The use of the Friction Clutch other than intended purpose may result in injury or property damage.
Prohibited
• When carrying a lifted load using a lifting magnet or a vacuum chuck, lower the height of the lifted load as low
as possible.
• When lifting a load with two electric chain hoists, use the electric chain hoist with the rated lifting capacity of a
Mandatory
single hoist exceeding the load.
• When lifting a load with two electric chain hoists, use the electric chain hoists of the same model and capacity
and operate the respective electric chain hoist to keep the load lifted or lowered horizontal.
Failure to comply with this instruction causes bodily injury or loss of property.
■ Traverse / Travel
• Do not operate the electric chain hoist underneath the load or transport a load over people. (Fig. I)
• Do not operate the electric chain hoist when any person is in the area where the
lifted load moves.
Prohibited
• Do not allow people to enter into the area where a lifted load moves.
• Do not ride on a lifted load and do not use the electric chain hoist to support, lift,
or transport people. (Fig. J)
• Do not strike the stopper or the structure by the body size or the trolley.
• Do not operate or move the electric chain hoist while going backward with a load kept lifted.
Operate the electric chain hoist while looking forward from the back of a load and going ahead.
Failure to comply with these instructions may result in death or serious injury.
• Do not impede the lifted load with other structure or wiring.
Failure to comply with this instruction causes bodily injury or loss of property.
Prohibited
• If the Load Chain and the hand chain of the geared trolley are entangled, stop the operation immediately and
reset the entangled chains.
Failure to comply with this instruction causes bodily injury or loss of property.
Mandatory
■ In Abnormality or Failure
• If the electric chain hoist is damaged or abnormal noise or vibration occurs, stop the operation immediately.
• If the electric chain hoist moves in the direction opposite to the indication on the Push Button Switch, stop the operation
immediately.
Mandatory
• When the twist, entanglement, crack, deformation, attachment of foreign matters or abnormal engagement of the Load
Chain and the Gear is observed, stop the operation immediately.
• When any abnormality is observed during the operation, indicate "FAILURE" and contact with the maintenance engineers.
• When the power is interrupted, secure safety and contact with the maintenance engineers.
Failure to comply with these instructions may result in death or serious injury.
CAUTION
DANGER
CAUTION
DANGER
I J
(to be continued)
33
1 1