Changing Engine Oil - probst VM-301-PAVERMAX Mode D'emploi

16 PERIODIC SERVICE
4. If the oil level is too low, remove the oil filler plug, and
add new oil to the prescribed level.
5. After adding oil, wait more than 5 minutes and check
the oil level again. It takes some time for the oil to
drain down to the oil pan.
Engine oil quantity
Model
D1005-E3, D1105-E3, D1105-TE3
D1305-E3
V1505-E3
V1505-TE3
Oil quantities shown are for standard oil pans.
A Engine oil should be MIL-L-2104C or have
properties of API classification CF or higher.
Change the type of engine oil according to the
ambient temperature.
above 25°C (77°F)
0°C to 25°C (32°F to 77°F)
below 0°C (32°F)
A When using oil of different brands from the previous
one, be sure to drain all the previous oil before
adding the new engine oil.
Quantity
5.1 L (1.35 U.S. gals.)
5.7 L (1.51 U.S. gals.)
6.0 L (1.59 U.S. gals.)
6.7 L (1.77 U.S. gals.)
SAE30 or SAE10W-30
SAE10W-40
SAE20 or SAE10W-30
SAE10W-40
SAE10W or SAE10W-30
SAE10W-40
BChanging engine oil
CAUTION
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container underneath the
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 200 hours thereafter.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier
when the oil is warm.
(1) Oil drain plug
3. Add new engine oil up to the upper limit of the oil
level gauge.