Changing Engine Oil; Replacing The Oil Filter Cartridge - probst POWERPLAN PP Manuel D'utilisation

16 PERIODIC SERVICE
BChanging engine oil
CAUTION
To avoid personal injury:
A Be sure to stop the engine before
draining engine oil.
A When draining engine oil, place
some container underneath the
engine and dispose it according to
local regulations.
A Do not drain oil after running the
engine. Allow engine to cool down
sufficiently.
1. Change oil after the initial 50 hours of operation and
every 200 hours thereafter.
2. Remove the drain plug at the bottom of the engine,
and drain all the old oil. Drain oil will drain easier
when the oil is warm.
(1) Oil drain plug
3. Add new engine oil up to the upper limit of the oil
level gauge.
BReplacing the oil filter cartridge
CAUTION
To avoid personal injury:
A Be sure to stop the engine before
changing the oil filter cartridge.
A Allow engine
sufficiently, oil can be hot and cause
burns.
1. Replace the oil filter cartridge after the initial 50
hours of operation and every 200 hours thereafter.
2. Remove the old oil filter cartridge with a filter wrench.
3. Apply a film of oil to the gasket for the new cartridge.
4. Screw in the cartridge by hand. When the gasket
contacts the seal surface, tighten the cartridge
enough by hand. Because, if you tighten the
cartridge with a wrench, it will be tightened too much.
(1) Oil filter cartridge
Remove with a filter wrench
(Tighten with your hand)
5. After the new cartridge has been replaced, the
engine oil level normally decreases a little. Thus, run
the engine for a while and check for oil leaks through
the seal before checking the engine oil level. Add oil
if necessary.
A Wipe off any oil sticking to the machine completely.
to cool down