Configuration; Osm Interface (On Screen Menu); Using The Osm; How To Use The Joystick - Videotec ULISSE Manuel D'instructions

10 Configuration

10.1 OSM interface (On Screen
Menu)

10.1.1 Using the OSM

During normal operation of the unit, you can activate
the OSM to select and configure advanced functions..
For further information, refer to the manual of the
keyboard used and to the relative chapter. (12.11
Special controls, page 62).
Exit the OSM with Wide Zoom (Zoom-).
This is a dynamic self-configuration menu
based on the Pan & Tilt model.

10.1.1.1 How to use the joystick

All operations in the menus are carried out using the
joystick.
Left
Fig. 66 Pan & tilt.
Exit
Fig. 67
Wide Zoom and Tele Zoom.
If you use control keyboards with 2-axes
joystick, use the Wide Zoom and Tele Zoom
buttons to Exit and Confirm.
MNVCUPTDMB_2104_EN
Up
Right
Down
Confirm

10.1.1.2 How to move around the menus

Each page of the OSM shows a list of parameters
or sub-menus that can be selected by the operator.
Move the cursor with the joystick (up and down) to
scroll the various parameters .
MANUAL CONTROL
------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 68
The symbol > at the end of a line indicates the
presence of a specific submenu. To enter the
submenu just confirm the menu item. To exit the
submenu use the Exit function (Zoom Wide).
MANUAL CONTROL
------------------------
1 MAXIMUM SPEED
2>VEL. WITH ZOOM :
3 TILT FACTOR
4 MOVEMENT LIMITS
Fig. 69
: 20.00
N
: 2
>
: 20.00
N
: 2
>
37