Manually Activate The Led Illuminators - Videotec ULISSE Manuel D'instructions

8.11.6 Manually activate the LED
illuminators
To turn on the LED illuminators:
• Adjust the left illuminator (MASTER):
• Lighting threshold: Set the value to the
minimum (8.11.7 LED illuminator switching on
threshold adjustment, page 32).
• Infrared power: Set the value as needed (8.11.8
LED illuminator power adjustment, page 32).
• Adjustment of the the illuminator on the right
(SLAVE):
• Lighting threshold: Set the value to the
maximum (8.11.7 LED illuminator switching on
threshold adjustment, page 32).
• Infrared power: Set the value to the minimum (
8.11.8 LED illuminator power adjustment, page
32).
MNVCUPTDMB_2104_EN
• Set the Off value under IR Probe in the Main menu
> Block camera > Advanced > Infrared menu (
10.1.8.10 Advanced Setting Menu (Infrared), page
50).
INFRARED
------------------------
1>IR PROBE
Fig. 51
For further details on configuration and use refer
to the relative chapter (12.9 Enabling the LED
illuminator, page 61).
: OFF
31