Autopan Enabling; Enabling The Wiper (Wiper); Enabling The Washer (Washer); Enabling The Led Illuminator - Videotec ULISSE Manuel D'instructions

12.6 Autopan enabling

The Autopan function loads the 2 saved Presets in a
continuous manner.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (12.11 Special controls, page 62).
To deactivate this function, move the joystick or
restore a different type of movement.
Refer to the relative chapter for the configuration of
this function (10.1.9.7 Autopan Menu, page 54).

12.7 Enabling the wiper (Wiper)

Do not use the wiper when the outside
temperature is below 0°C or in case of ice.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (12.11 Special controls, page 62).
If it is left on, the wiper automatically
disables itself.
MNVCUPTDMB_2104_EN
12.8 Enabling the washer
(Washer)
When a control is provided, the Pan & Tilt is
positioned with the window in front of the nozzle..
The pump and wiper are activated for a set period of
time. At the end of the operation the P&T returns to
its initial position.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (12.11 Special controls, page 62).
To activate special configurations, refer to the relative
chapter (12.12 Special configurations, page 63).
For models with washer complete with level sensor,
can also display a video message when the level of
the liquid inside the tank is too low (only if using a
high prevalence pump).

12.9 Enabling the LED illuminator

If the system is not provided with a dusk switch, you
can activate/deactivate the LED illuminator with the
specific control (12.11 Special controls, page 62).
Refer to the relative chapter for the manual activation
configuration (8.11.6 Manually activate the LED
illuminators, page 31).

12.10 Unit Reboot

Using the control device it is possible to reboot the
unit (for further information refer to the manual of
the control device in use).
For further information refer to the relative chapter (
12.11 Special controls, page 62).
61