Configuration; Default Ip Address; Web Interface - Videotec MAXIMUS MPX 2 Serie Manuel D'instructions

7 Switching on
Before carrying out any type of
maintenance, read the "Safety rules"
chapter carefully in the product manual.
The automatic pre-heating (De-Ice)
process could be started whenever the
device is switched on and the ambient
temperature is below -10°C (+14°F). The
procedure is necessary to guarantee
correct operation of the devices even at
low temperatures. The duration ranges
depending on environmental conditions
(from 60 minutes up to 120 minutes).
The unit is switched on by connecting the power
supply.
It takes a few minutes for the unit to become fully
operational after it is switched on.
To switch off the unit disconnect the power.
34

8 Configuration

8.1 Default IP address

The unit is configured to obtain an IP
address from a DHCP server.
The IP address acquired via DHCP is visible in the
DHCP server log file.
If the DHCP server is not available, the unit
automatically configures itself with a self-generated
IP address in the 169.254.x.x/16 subnet. Configuring
the IP address of the PC as belonging to the same
subnet (example: IP address: 169.254.1.1, subnet
mask: 255.255.0.0).
Use an ONVIF compliant VMS or a network sniffer to
find the IP address of the device (IP scan utility).

8.2 Web interface

8.2.1 First access to the web pages
The first operation in configuring the device consists
in connecting to the web interface.
To access the web interface of the product, simply
use a browser to connect to http://ip_address.
On first access, the Home page will be displayed.
To configure the web interface, consult the manual
relating to the firmware version installed, available
on the product web page of the website www.
videotec.com.
MNVCMPXHDC_2222_EN