6 Configuration
The RS-485 line must always be connected
when configuring the device functions
and performing firmware updates of the
boards.
Configuration of the product can be carried
out using the OSM (On Screen Menu) interface:
configuration via the text on the analogue video
signal.
6.1 OSM interface (On Screen
Menu)
It is possible to enable the OSM by
connecting the grey and green wires of the
I/O cables for 5 seconds (Tab. 4, page 9).
6.1.1 Using the OSM
During normal operation of the unit, you can
activate the OSM to select and configure advanced
functions.
Exit the OSM with Wide Zoom (Zoom-).
12
6.1.1.1 How to use the joystick
All operations in the menus are carried out using the
joystick.
Left
Fig. 3
Browsing the menu.
Exit
Fig. 4
Wide Zoom and Tele Zoom.
If you use control keyboards with 2-axes
joystick, use the Wide Zoom and Tele
Zoom buttons to Exit and Confirm.
Up
Right
Down
Down
Down
Confirm
MNVCMVXTCAM_2121_EN