Washer Menu; Default Menu; Info Menu - Videotec ULISSE Manuel D'instructions

10.1.11.2 Washer Menu

The P&T offers the possibility to use a wiper and to
operate a pump to clean the glass.
To configure the Washer put the lens of the camera in
front of the nozzle of the Washer.
Save a preset (XY) that identifies this position; the
preset will be recalled by the pan & tilt when the
WASHER function is enabled.
Configure the following parameters:
Enable: Enabling the Washer function.
1.
Nozzle Preset: Enter the preset number (XY)
2.
corresponding to the nozzle.
Wiper On Delay: Select the time interval
3.
between the pump and wiper.
Washing Length: Choose the duration of
4.
brushing.
Wiper Off Delay: Choose the duration of
5.
brushing without water.
WASHER
------------------------
1>ENABLE
2 NOZZLE PRESET
3 WIPER-ON DELAY
4 WASHING DURATION
5 WIPER-OFF DELAY
Fig. 119
MNVCUPTDMB_2104_EN

10.1.12 Default Menu

1.
2.
Fig. 120
: N

10.1.13 Info Menu

: 1
: 5
The menu is used to check the configuration of the
: 10
: 5 device and the installed firmware version.
Fig. 121
Delete Setup?: Resets all the parameters except
the Presets.
Delete Preset?: Deletes all previously stored
presets.
DEFAULT
------------------------
1>DELETE SETUP?
2 DELETE PRESET?
The above mentioned operations cause the
loss of all previously stored data (i.g. Preset,
Patrol, Autopan, Home...).
INFO
------------------------
Device ID: 00001
Type : Rs485 only Rx
Baud Rate: 38400-8N1
Protocol : MACRO
Net Board: Fw6.02 Hw01
Mpp Board: Fw6.02 Hw00
Config. : 001
P.C. : UPT1SVSA000E
S.N. : 000000000000
Upgrade : NET BOARD
57