Configuration; Sofware Interface; Minimum System Requirements; Configuration Procedure Through Software - Videotec MAXIMUS MPXHD Manuel D'instructions

9 Configuration

The product can be configured using one of the
following tools:
• Sofware interface: Configuration via the
application installed on PC.
• Web interface: Configuration via the browser.

9.1 Sofware interface

9.1.1 Minimum system requirements

The supplied controlling software supports up to 16
channels. The software requires Windows XP Service
Pack 3 or higher and a PC with an Xeon processor at
2.3GHz or higher.
9.1.2 Configuration procedure through
software
After installing, powering up and switching on
the product, now configure the IP settings (6.7
Connection of the Ethernet cable, page 20).
The IP address of the various units should be
configured using a PC.
Assign the following IP address to the PC:
192.168.10.1 (or 192.168.10.2).
Connect the unit to the LAN network, provide power
supply and start the browser (minimum Microsoft
Internet Explorer® 6.0).
To set the IP address of the various units,
power them, taking care to connect them
one at a time to the LAN (switch). Configure
the unit and insert the settings for at
least the IP address and host name. Once
configured, connect the Ethernet cable and
go on to configure the next unit.
Enter address: 192.168.10.100.
You will be asked login and password. When making
the settings for the first time insert the default login
and password.
• Login: admin
• Password: 1234
MNVCMPXHD_1607_EN
The product control interface is displayed if login is
successful.
Fig. 22
The product can operate using ONVIF or
TCAM protocols. In the event the ONVIF
protocol is used, make sure to set the time
correctly in the device or to configure an
NTP server. (9.2.5 Network Configuration,
page 29).

9.1.3 Installing the software

Insert the CD and start the autoplay or launch the
installer. A web page opens for the installation of the
TVMS server application (32 or 64 bit, based on the
computer's features).
You will be asked login and password. When making
the settings for the first time insert the default login
and password.
• Login: admin
• Password: 1234
Select Camera from the Setup menu to add the
device to the VMS.
Fig. 23
25