10.1.8.11 Advanced Setting Menu (White
Balance)
It allows you to configure the following parameters:
1.
Mode: Sets the type of control on White
Balance. The possible values are:
• Automatic: Sets automatic white balance.
This is the recommended solution.
• Manual: Enables manual setting of red and
blue gains.
• Outdoor: Sets fixed red and blue gains for
outdoor applications.
• Indoor: Sets fixed red and blue gains for
indoor applications.
• ATW: Enables Auto Tracing White Balance.
• Out Auto: Sets the red and blue gain values
for outdoors.
• Lamp Auto: Sets the red and blue gain values
for sodium vapour lamps.
• Lamp Fixed: Sets the red and blue fixed gain
values for sodium vapour lamps.
Red Value: Sets the value of the red gain.
2.
Blue Value: Sets the value of the blue gain.
3.
WHITE BALANCE
------------------------
1>MODE
2 RED VALUE :
3 BLUE VALUE:
Fig. 103
This is a dynamic self-configuration menu based on
the choice made and shows the parameters on which
it is possible to operate.
MNVCUPTDMB_2104_EN
:
MANUAL
0
0
10.1.8.12 Advanced Setting Menu (Other)
1.
Sharpness: Sets the sharpness value of the
image.
2.
High Resolution: Enables the High Resolution
function. The output video signal has a higher
resolution.
Wide Dynamic: Enables the Wide Dynamic
3.
function. It improves vision when some zones
within the frame are much brighter than others.
Stabilizer: Enables the electronic image
4.
stabilization function.
Progressive Scan: Enables the Progressive Scan
5.
function. Gives a more stable image when the
Pan & Tilt is connected to a video server.
Noise Reduction: Sets the noise reduction
6.
level. Vary the parameter according to the
environmental conditions to obtain a higher
contrast image.
OTHER
------------------------
1 SHARPNESS
2 HIGH RESOLUTION :
3 WIDE DYNAMIC
4 STABILIZER
5 PROGRESSIVE SCAN:
6 NOISE REDUCTION :
Fig. 104
This is a dynamic self-configuration menu based on
the Pan & Tilt model.
:
6
N
:
OFF
:
N
N
2
51