Fixing The Base To The Support - Videotec ULISSE Manuel D'instructions

8.2 Fixing the base to the support

Use the screws and the washers supplied
with the base.
Once you have positioned the gasket (01), fix the
base (02) onto the bracket (03) with screws (04),
serrated washers (05) and screw rings (06).
02
01
06
05
04
Fig. 18
02
01
06
05
04
Fig. 19
18
Align the 3 notches on the base with those on the
support as shown in the following figure.
Fig. 20
03
Tab. 4
03
Apply a thread-locker on the holes of the
screws (Loctite 243®).
Pay attention to the fixing. Tightening
torque: 4Nm.
MNVCUPTDMB_2104_EN