Configuration; Software Interface; Minimum System Requirements; Configuration Procedure Through Software - Videotec MAXIMUS MPXHD Manuel D'instructions

9 Configuration

The product can be configured using one of the
following tools:
• Software interface: Configuration via the
application installed on PC.
• Web interface: Configuration via the browser.

9.1 Software interface

9.1.1 Minimum system requirements

The supplied controlling software supports up to 16
channels. The software requires Windows XP Service
Pack 3 or higher and a PC with an Xeon processor at
2.3GHz or higher.
9.1.2 Configuration procedure through
software
After installing, powering and switching on the
product (6.7 Connection of the Ethernet cable, page
20), proceed to the IP parameters configuration.
The IP address of the various units should be
configured using a PC.
Assign the following IP address to the PC:
192.168.10.1 (or 192.168.10.2).
Connect the unit to the LAN network, provide power
supply and start the browser (minimum Microsoft
Internet Explorer® 6.0).
MNVCMPXHD_1801_EN
To set the IP address of the various units,
power them, taking care to connect them
one at a time to the LAN (switch). Configure
the unit and insert the settings for at
least the IP address and host name. Once
configured, connect the Ethernet cable and
go on to configure the next unit.
Enter address: 192.168.10.100.
You will be asked login and password. When making
the settings for the first time insert the default login
and password.
• Login: admin
• Password: 1234
The product control interface is displayed if login is
successful.
Fig. 21
The product can work via ONVIF or TCAM
(VIDEOTEC) protocol. In the event the
ONVIF protocol is used, make sure to set the
time correctly in the device or to configure
an NTP server. (9.2.5 Network Configuration
page, page 30).
25