Sun SWB 340 Notice D'utilisation page 82

26
82
20
5-33
28
26
5-34
21
5-35
5-36
Operation
5.11.3 Start optimisation/weight
minimisation
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions and check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 20
Optimisation – Minimisation (Fig. 5-33).
The OPTIMISATION MENU
(Fig. 5-34).
If an optimisation/minimisation result has already
been saved, press the key 21 (Fig. 5-35); in this way,
the program continues from the step where it was
interrupted, with the relative measurement values
and settings, and the optimisation/minimisation may
continue.
At this point, you can choose whether to continue
Optimisation (Key 26), or go to Minimisation (Key 28).
5.11.3.1 OPTIMISATION
— Clamp the rim only.
— Move the gauge into position on the rim, based on
the desired ALU.
— Perform a measuring run.
— In the BALANCING menu press key 20 (Fig. 5-33).
The "OP.1" screen page appears (Fig. 5-34).
— Press the menu key 26 (Fig. 5-34).
The OPTIMISATION "OP.2" screen is displayed (Fig.
5-36).
"OP.1" screen is displayed