Sun SWB 340 Notice D'utilisation page 138

4
1 2
3
B
138
C
2a 1a
3a
7-10
A
D
7-11
User Code
Enable the network mode / remote printing / the
remote report
After connecting the machine to the network, and
installing the software (available on request) on the
workshop computer, enable the network mode for the
data exchange functions on the balancer.
For the NETWORK MODE select (Fig.7-10):
— (4), (C), (1), (1a),
No network(*) = Disables the communication
ASA = Enables the Asa Network protocol
Snap-on Network = Enables the Snap-on Network
Sonnet2 = Enables Sonnet 2 protocol
After the activation, in the BALANCING (Fig.7-11) the
NETWORK (A) button will be available to access the
REPORT (B) and PRINT (D) functions.
For the PRINT select (Fig.7-10):
— (4), (C), (2), (2a),
Disabled(*) = Print disabled
Enabled = Print enabled
Note: The Print function, if enabled in the Disabled network
mode, will be available for the direct communication with
the machine USB port.
To exchange REPORTS select (Fig.7-10):
— (4), (C), (3), (3a),
Disabled(*) = Report off
Enabled = Report on
* = Factory confi guration