38
4-14
Operation
4.8
Stop button
Refer to (Figure 4-14).
To perform an immediate stop:
• Press the Electromechanical stop button;
The electronic brake is activated to immediately stop
wheel shaft rotation, as well as any other balancer
automatic movement.
In the event of a stop due to an unexpected action by
the unit, reconstruct the steps taken:
Did the operator make an error or omit to do
something?
Correct the input and continue working. No special
procedure is required.
Did the unit do something unexpected?
• Read the relevant chapters again.
• Prepare the unit for a restart:
switch the unit off and on again.
• Carefully repeat the commands following the
instructions in the operator's manual.
• If the unit does not function correctly,
WARNING: PREVENT ANY FURTHER USE OF THE
UNIT.
• Call the service immediately.