Test Procedures; Instructing The Operator - Sun SWB 340 Notice D'utilisation

1
150
iii-5
Installation
Electrical Connection
Figure iii-5 Power Supply
Caution
Before connecting the electronic cables turn off the
mains switch.
— Plug in the plug (1, Fig.iii-5) of the power supply
cable.
iv Test procedures
• Balance a wheel until obtaining an unbalance less
than 5 grams (0.25 oz.) per plane.
• Perform a User Calibration,
v Instructing the operator
(Following applies only if a unit is installed by a service
Technician)
• Show and explain the Safety Booklet.
• Show the operator how to switch the unit on and
off.
• Show the operator how to perform an emergency
stop.
• Show the operator how to select a wheel type, enter
data and apply a weight.
F
6.2.