Angelo Po FX61 G3 Manuel D'installation Et Mode D'emploi page 85

KEY TO ALARM TABLE (Continued
Alarm Fault
E10
compartment has
overheated
E11
E13 diagnostics tripped
E14
E19 The humidity probe has
failed or is not properly
connected
E20 Setup error
E21 The washing cycle
has been interrupted
because there is no
cleaner
E22 The washing cycle
has been interrupted
because there is no
sanitizing cleaner
E23 The washing cycle has
been interrupted during
stage
E24
E26 system failure
E25
not completed
E27 Failure test gas
E28
open
Remedy
The oven solves the problem on its own
Call an authorized service agent
Call an authorized service agent
Call an authorized service agent
Check the pipe position and the level of
cleaner in the tank; top up if necessary and
restart the washing cycle.
If it is not possible to complete the cleaning
rinse the cooking chamber by hand
Check the pipe position and the level of
sanitizing cleaner in the tank; top up if
necessary and restart the washing cycle.
If it is not possible to complete the cleaning
rinse the cooking chamber by hand
Press the reset button and rinse the cooking
chamber thoroughly by hand.
Operate the oven in convection mode to dry
the cooking chamber.
Check that no residues of cleaning products
have been left inside the cooking chamber.
Rinse the cooking chamber by hand.
Check the position of the pipe and the level
cleaning cycle.
Call an authorized service agent
Press the "Reset" button
Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
Notes
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions
are disabled; no cooking
cycles can be performed
call an authorized service
agent
call an authorized service
agent
call an authorized service
agent
call an authorized service
agent
The oven's functions
are enabled so cooking
cycles can be performed
call an authorized service
agent
The oven's functions are
enabled; cooking cycles
can be performed
Call an authorized
service agent
85