Maintenance - Angelo Po FX61 G3 Manuel D'installation Et Mode D'emploi

Four combiné
Masquer les pouces Voir aussi pour FX61 G3:
Table des Matières

Publicité

MAINTENANCE RECOMMENDATIONS
performing the scheduled maintenance procedures
recommended
by
longer working life and constant maintenance of
safety requirements.
Before
WARNING
servicing procedure activate all the safety
devices
provided
orkers and those in the vicinity should e
infor
ed. In particular turn off the gas and
ater supply valves disa le the electricity
supply using the
access to all devices that
unexpected health and safety hazards if
turned on.
WARNING Before perfor
that
involves
electrical
disconnection and/or exposure to electrical
co ponents al ays follo
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to co ply can cause
property da age in ury or death.
At the end of each session of use and whenever
obstructed (Make sure that the combustion
appliance and clean it if it is dirty or obstructed
Every year
perform the following operations:
clean if necessary
exchanger and replace if necessary.
replace if necessary and that the power supply
cable is intact
inspection window and combustion air fan

MAINTENANCE

the
manufacturer.
Perfor
ing
and
decide
aster s itch and prevent
ight cause
ing any service
connection
the Electrical
dioxide (CO
Proper
any
IMPORTANT _________________________
hether
Record the yearly inspections.
IMPORTANT _________________________
Contact
representative or an authorized service
agent to perfor
ELECTRICAL LOCKOUT/TAGOUT
or
PROCEDURE
WARNING Before perfor
that
involves
disconnection and/or exposure to electrical
co ponents al ays follo
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to co ply can cause
property da age in ury or death.
used to protect personnel working on an electrical
appliance. Before performing any maintenance
or service that requires exposure to electrical
into OFF position.
2. Place a lock or other device on electrical box
cover to prevent someone from placing circuit
breaker ON.
3. Place a tag on electrical box cover to indicate
that appliance has been disconnected for
service and power should not be restored until
tag is removed by maintenance personnel.
4. Disconnect appliance power cord from electrical
outlet.
5. Place a tag on the cord to indicate that unit
zshould not be restored until tag is removed by
maintenance personnel.
Combination Oven Installation and Operation Manual
2
the
factory
the
aintenance and repairs.
ing any service
electrical
connection
the Electrical
Section 6
Maintenance
factory
or
37

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Table des Matières