Section 8
Troubleshooting
KEY TO ALARM TABLE
Alarm
Fault
H2O
water pressure too low
H2O.
pressure too low
GAS
failure
OPE
Oven door opening or
closure request
CLE
Indicates that cleaning is
required
E01
The cooking chamber probe
has failed or is not properly
connected
E02
The core probe has a failure
or has not been properly
connected
E03
The steam discharge probe
has failed
E04
not positioned correctly
E05
Safety thermostat failure
E06
Overload cutouts tripped
E07
Overload cutouts tripped
E08
The optional vacuum probe
has failed or is not properly
connected
48 Combination Oven Installation and Operation Manual
Remedy
Check that mains water is
persists call an authorized
service agent
Check that water supply is
persists call an authorized
service agent
Press reset button (the button
may have to be pressed
persists call an authorized
service agent
Open or close the oven
service agent if this message
continues to be displayed
cycle
Call an authorized service
agent
Check the position of the
product core probe or call an
authorized service agent if it is
faulty
Call an authorized service
agent
Switch on the oven again and
if the problem persists call an
authorized service agent
Call an authorized service
agent
Call an authorized service
agent
Contact an authorized service
agent
Press the "Reset" button
Notes
Convection cooking cycles can still
be performed
Convection and steam cooking
cycles can still be performed
Stop cooking if this message is
repeated more than once
The cooking cycle does not start
until the door has been opened or
closed as required
The oven's functions are enabled;
cooking cycles can be performed
The oven's functions are disabled;
no cooking cycles can be
performed
Cooking cycles with product core
probe cannot be performed
Convection and steam cooking
cycles can still be performed
Convection and steam cooking
cycles can still be performed
The oven's functions are disabled;
no cooking cycles can be
performed
The oven's functions are disabled;
no cooking cycles can be
performed
The oven's functions are disabled
so no cooking cycles can be
performed
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle. If the problem
agent