Angelo Po FX61 G3 Manuel D'installation Et Mode D'emploi page 232

Section 5
Operation
Press the button and turn knob (21) to modify the
value set.
With the appliance in STOP mode (icon (16)
(12) longer than 3 seconds (the whole panel
Press button (5) and turn knob (21) to turn the
automatic preheating on or off. Press knob (21)
6. Humidity percentage setting key
percentage of humidity using knob (21). Wait about
5 seconds for the new value set to be saved.
Modify the percentage of humidity during
cooking: press once to display the value of
Press the button and turn knob (21) to modify
the value set. Wait about 5 seconds for the new
value set to be saved.
In "Convection cooking" mode you can adjust
the percentage of opening of the vent, which is
shown on display (9) ("0" = vent always open;
"100" = vent always closed).
"Steam cooking" mode.
CIBUS PLUS 1:
CIBUS PLUS 2:
function. This mode recommended for stringy
7. Temperature display
To display the real temperature inside the
the start of a cooking process when temperature
inside the oven is higher than temperature set
temperature has not been reached.
the number of "Regeneration" programs
available for selection using button (18).
28 Combination Oven Installation and Operation Manual
8. Time and "product core probe" display
(4) approximately
9. Humidity percentage display
1
7
4
5
6
12
13
16
17
18
21
Press button (5)
the value of time set.
remaining to the end of the cooking cycle.
Press button (10)
the value of temperature set.
of temperature measured by the probe.
the display shows the value of percentage
humidity set.
2 3
8
9
10
11
15
14
20
19
22
("product core probe"