Angelo Po FX61 G3 Manuel D'installation Et Mode D'emploi page 243

9. Take special care not to damage stainless steel
products or chlorines and do not use abrasive
materials or sharp tools.
10. Remove food residues immediately before they set.
11. Remove any lime scale deposits which may
form on some of the appliance's surfaces.
CLEANING T E COOKING C AMBER
Whenever the cooking
CAUTION
is changed clean the cha
For cleaning and re oving unpleasant
s ells use the products reco
the "Cleaning Products" ta le.
Do not spray ets of cold
CAUTION
on the light xture or the glass of the door
hen the te perature in the cha
a ove 302 F 150 C .
2. Remove container racks
the cooking chamber with water.
and leave it to act for 10 – 15 min.
The "cleaning spray" should be used to spray the
cleaner onto the inside of the cooking chamber.
er thoroughly.
ended in
from the oven
(C).
A
the surfaces of the cooking chamber.
8. Spray on the polishing product and leave it to act
for a few minutes.
the surfaces of the cooking chamber.
panel (D).
11. Replace the container racks
mesh (C).
CAUTION
cleaning procedures
ode
cycle e pty in "Stea "
and for an additional 15
ode at a te perature of 302 F 150 C
efore re using the appliance.
If the oven is to e unused for short periods
ater
leave the cooking cha
condensation fro
er is
(D).
Combination Oven Installation and Operation Manual
Upon co pletion
perfor
ode for 15
in. in "Convection"
er open to prevent
for ing.
D
C
B
Section 6
Maintenance
of the
a cooking
in.
39