Angelo Po FX61 G3 Manuel D'installation Et Mode D'emploi page 24

Section 4
Handling and Installation
IMPORTANT _________________________
1. Turn on gas and water supply valves and check
that connections are tight.
2. Turn on the master switch to check the electrical
connection.
3. Check that the mains gas is the same as that
carry out the conversion procedure if necessary.
4. Check that the gas pressure conforms to values
stated in the table at the back of the manual.
5. Check that the combustion exhaust gases
comply with the requirements.
7. Check that the safety device is operating correctly.
8. Carry out a cooking cycle without food to ensure
the appliance is operating correctly.
accordance with all legal requirements.
IMPORTANT _________________________
RECOMMENDATIONS FOR
IMPORTANT _________________________
activate all the safety devices provided and
cause unexpected health and safety hazards
if turned on.
24 Combination Oven Installation and Operation Manual
WARNING
that involves electrical
disconnection and/or exposure to electrical
LOCKOUT/TAGOUT Procedure. Disconnect
WARNING
1. Turn off gas supply valve (A).
(C).
4. Connect pressure gauge (D) to pressure test
5. Turn gas supply valve (A) back on.
C
D
E
6. Switch on the appliance and perform a cooking
cycle without food at maximum temperature.
7. Check the pressure gauge reading complies
with the values.
Gas type Pressure in kPa (Inches Water Column)
rated
Natural gas
Propane
valve (A)
retighten screw (C).
connection
(B).
B
A
minimum maximum
(D) and
or