9. Replace panel (B) and retighten screws when
the operation is complete.
analyze the combustion exhaust gases:
the instrument in accordance with instructions in
the operator's manual supplied with it.
2. Insert exhaust gas analyzer measuring pipes
into the appliance's exhaust gas discharge lines.
3. Switch on the appliance.
2
Measurement" procedure.
5. Check CO and CO
6. Check that readings obtained are as required by
the manufacturer.
it to the manufacturer to activate the Warranty.
IMPORTANT _________________________
F
C
2
E
D
G
2. Turn on water supply valve (B).
bring the pressure reading on pressure gauge
(E)
If the water pressure is too low, install a device
to increase the pressure.
5. Retighten ring nut (C).
7. Turn screw (G)
to bring pressure reading on pressure gauge (H)
If the water pressure is too low, install a device
to increase the pressure.
8. Retighten ring nut (F).
9. Return panel (A) to it's original position and
replace screws.
10. Turn water supply valve (B) off when the
operation is complete.
A
Combination Oven Installation and Operation Manual
Handling and Installation
(C).
(D)
(F).
B
Section 4
(A).
25