Change Assignment Of The Leds (Device Status) - Burkert 8695 Manuel D'utilisation

Type 8695
AS Interface Installation
10.5.3. change assignment of the leds (device status)
Danger!
risk of electric shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
Procedure:
→
Open the control head: turning the transparent cap anti-clockwise.
→
Using the jumpers, assign the required color to the LEDs (see „Figure 25: Description LED and Jumpers - AS
Interface").
noTe!
damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674078
The assembly tool (674078) is available from your Bürkert sales office.
4)
).
4)
english
37