Installation; Safety Instructions; Installation Of The Control Head Type 8695 On Process Valves Of Series 21Xx (Element) - Burkert 8695 Manuel D'utilisation

Type 8695

Installation

7. insTallaTiOn
7.1. safety instructions
Danger!
risk of injury from high pressure!
• Before dismounting pneumatic lines and valves, turn off the pressure and vent the lines.
risk of electric shock!
• Before reaching into the device or the equipment, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
Warning!
risk of injury from improper installation!
• Installation may be carried out by authorized technicians only and with the appropriate tools!
risk of injury from unintentional activation of the system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following assembly, ensure a controlled restart.
7.2. installation of the control head Type 8695
on process Valves of series 21xx (element)
Procedure:
1. install switch spindle
(plug-in hose connectors with collets or
threaded bushings)
Figure 4: Installation of switch spindle (1), series 21xx
→
Unscrew the transparent cap on the actuator and unscrew the position display (yellow cap) on the spindle
extension (if present).
→
For version with plug-in hose connector, remove the collets (white nozzles) from both pilot air ports (if
present).
Transparent cap
Pilot air ports
Actuator
english
15