Type 8695
AS Interface Installation
10.4. electrical installation as interface
10.4.1. safety instructions
Danger!
risk of electric shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
Warning!
risk of injury from improper installation!
• Installation may be carried out by authorized technicians only and with the appropriate tools!
risk of injury from unintentional activation of the system and an uncontrolled restart!
• Secure system from unintentional activation.
• Following installation, ensure a controlled restart.
10.4.2. connection with circular plug-in connector M12 x 1,
4-pole, male
→
Connect the control head according to the table.
Bus connection (circular plug M12 x 1, 4-pole, male)
Figure 21:
Circular plug M12 x1, 4-pole
pin
designation
1
Bus +
2
NC
3
Bus –
4
NC
Table 7:
Pin assignment of circular plug-in connector for AS Interface
4
3
NC
Bus -
Bus +
NC
2
1
configuration
AS Interface bus line +
not used
AS Interface bus line -
not used
english
33