Burkert 8695 Manuel D'utilisation page 18

Masquer les pouces Voir aussi pour 8695:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3. install control head
Align the puck holder and the control head until
1. the puck holder can be inserted into the guide rail of the control head
and
2. the supports of the control head can be inserted into the pilot air ports of the actuator (see also "Figure 8:
Installation of control head").
noTe!
damaged printed circuit board or malfunction!
• Ensure that the puck holder is situated flat on the guide rail.
Supports
Figure 7:
Aligning the puck holder and the supports
Push the control head, without turning it, onto the actuator until no gap is visible on the form seal.
noTe!
too high torque when screwing in the fastening screw does not ensure protection class ip65 / ip67!
• The fastening screws may be tightened to a maximum torque of 0.5 Nm only.
Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the screws
only hand-tight (max. torque: 0.5 Nm).
18
english
Guide rail
Puck holder
Guide rail
Puck holder
Type 8695
Installation

Publicité

Table des Matières
loading

Table des Matières