Change Assignment Of The Leds (Device Status) - Burkert 8695 Manuel D'utilisation

Type 8695
Electrical Installation 24 V DC
9.3.2. change assignment of the leds (device status)
Danger!
risk of electric shock!
• Before reaching into the system, switch off the power supply and secure to prevent reactivation!
• Observe applicable accident prevention and safety regulations for electrical equipment!
Procedure:
→
Open control head: turn the transparent cap anti-clockwise.
→
Using the jumpers, assign the required color to the LEDs.
Figure 20: Description LED and Jumper - 24 V DC
noTe!
damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent cap in all the way.
→
Close the device (assembly tool: 674078
The assembly tool (674078) is available from your Bürkert sales office.
3)
End position LED green
Jumper for
assignment of LEDs,
end position
End position LED yellow
).
3)
Jumper setting 1:
Top
Bot
In the end position top (Top),
ye ye
the yellow LED is lit; in the
gn gn
end position bottom (Bot),
the green LED is lit.
Bot Top
Jumper setting 2:
Top
Bot
In the end position top (Top),
ye
ye
the green LED is lit; in the
gn gn
end position bottom (Bot),
Bot Top
the yellow LED is lit.
english
31