Burkert 8695 Manuel D'utilisation page 20

Figure 10: Installation of the switch spindle (2), series 20xx
→
Press the O-ring downwards into the cover of the actuator.
→
Manually screw the switch spindle (and the plugged-on guide element) together with the plastic part onto the
spindle of the actuator, but do not tighten spindle yet.
→
Tighten the guide element with a face wrench
→
Tighten the switch spindle on the spindle of the actuator. To do this, there is a slot on the upper side (torque:
1.0 Nm).
→
Push the puck holder onto the switch spindle until it engages.
journal Ø: 3 mm; journal gap: 23.5 mm
1)
2. install control head
Figure 11: Aligning the puck holder
20
Guide rail
Puck holder
english
Puck holder
Switch spindle
Guide element
O-ring
Plastic part
(of the switch spindle)
Spindle (actuator)
into the actuator cover (torque: 8.0 Nm).
1)
Guide rail
Puck holder
Type 8695
Installation