Device Status - Assignment Of The Leds - Burkert 8695 Manuel D'utilisation

10.5.2. device status - assignment of the leds
The device status (end position) is displayed optically by colored LEDs.
Figure 25: Description LED and Jumpers - AS Interface
noTe!
damage or malfunction due to penetration of dirt and humidity!
• To observe protection class IP65 / IP67, screw the transparent cap in all the way.
The following functions are shown as standard
color
green LED on
yellow LED off
Table 10: Assignment of LEDs - AS Interface
Jumper function:
You can set the colour assignment of the end positions with the jumpers.
You can indicate for each colour whether it applies to the Top (end position top) or Bot (end position bottom).
36
end position
led green
Jumper for
assignment of
end position LEDs
end position
led yellow
Device status
End postion bottom
End postion top
english
Type 8695
AS Interface Installation
Jumper setting 1:
Top Bot
In the end position top
ye ye
(Top), the yellow LED
gn gn
is lit; in the end position
Bot Top
bottom (Bot), the green
LED is lit.
Top
Bot
Jumper setting 2:
ye
ye
In the end position top
gn gn
(Top), the green LED is lit;
in the end position bottom
Bot Top
(Bot), the yellow LED is lit.