10.4.3. connection with multi-pole cable and ribbon cable terminal
As an alternative to the bus connection model with 4-pole circular plug, there is the control head with multi-pole cable
(M12 circular plug) and ribbon cable terminal. The wiring diagram of the circular plug corresponds to the bus con-
nection of the M12 4-pole circular plug and can easily be connected to the ribbon cable terminal (see "Figure 23").
Figure 22:
Control head 8695 with multi-pole cable and ribbon cable terminal
handling the ribbon cable terminal
The multi-pole cable features a ribbon cable terminal - with M12 plug-in connector branch circuit - for AS Interface
cable harness. The ribbon cable terminal contacts the AS Interface cable harness by means of penetration technology
which allows installation by "clipping in" the AS Interface cable harness without cutting and without removing insulation.
Figure 23:
Ribbon cable terminal
34
Screws
M12 plug-in con-
nector branch circuit
english
Type 8695
AS Interface Installation
Work steps:
→
Open the ribbon cable terminal
(loosen screws and remove cover)
→
Insert cable harness conclusively
→
Close ribbon cable terminal again
→
Tighten screws
Slightly undo thread-forming screws
(approx. 3/4 turn to the left) and position them on the
existing tapped bore and screw in.