Locking And Unlocking The Keypad; Before The Installation - Burkert 0911 Instructions De Service

NOTE All parameter values can be seen by repeatedly pressing the
SET buttons.

LOCKING AND UNLOCKING THE KEYPAD

2.3

Before the installation

PREDEFINE THE SENSOR TYPE
Hold down the buttons
seconds. The POF message appears on the
display.
The keyboard is locked. You can only view the
set-value and the minimum and maximum
temperature. The POF message also appears if you
hold down a button for longer than 3 s.
The keyboard will be unlocked if you hold down
the buttons and
display for a few seconds.
The configurable input type is noted on the controller
label. Please enter this input type if it does not
corresponds to the connected sensor type.
Hold down the SET +
seconds.
Select the parameter Pbc (sensor type) and then
confirm with the SET button to see the current
default.
Type TU (temperature controller):
J = Thermoelement J; Pt = Pt100;
C = Thermoelement K; Ptc = PTC;
S = Thermoelement S; ntc = NTC
Type AU
(control devices with voltage/current input):
cur = 4...20 mA; 0-1 = 0...1 V; 10 = 0...10 V
Confirm the default with the SET button.
Briefly switch off the power to the device.
and for at least 3
for 3 s. POn appears in the
button for at least 3
0911 - 7