Installing All Other Docking Stations - Viking MI 632 M Manuel D'utilisation

1 Fold open the left clamping lever (1).
2 Insert the stripped wire end (2) into the
terminal block as far as it will go.
3 Close the clamping lever (1).
Strip the right wire end (1) to the specified
length X using a suitable tool and twist the
wire strands.
X = 10-12 mm
120
1 Fold open the right clamping lever (1).
2 Insert the stripped wire end (2) into the
terminal block as far as it will go.
3 Close the clamping lever (1).
Check the seating of the wire ends in the
terminal block: the two wire ends must be
firmly fastened.
● Close the panel. ( 9.4)
Close the cover of the cable duct (1).
Fit the cover and press OK. (
9.13 Installing all other docking
stations
When installing the other docking
stations please note that these
must be placed in alignment and
parallel to the master docking
station.
Note the "Docking zone installation
options" section, in particular
observe the minimum distances
between the docking stations!
( 9.1)
0478 131 9937 B - EN
9.4)