Connecting The Perimeter Wire - Viking MI 632 M Manuel D'utilisation

● If necessary, extend the perimeter wire
using the wire connectors supplied.
( 12.14)
● In the case of several adjacent mowing
areas, install secondary areas (
or join the mowing areas with corridors.
( 12.9)
Drive in the last fixing pin (1) on the left or
right next to the floor plate, directly next to
the wire outlet. Cut off the perimeter
wire (2). Provide free wire ends with a
length of approx. 1.5 m.
No fixing pins should be located at
positions where other docking
stations are placed, as the
perimeter wire is routed to the floor
plate of the docking station.
● Check the fastening of the perimeter
wire to the ground. One fixing pin per
metre is sufficient as a rough guide. The
perimeter wire must always lie on the
lawn. Drive the fixing pins fully into the
ground.
● After completing this installation
work, press the OK button on the
control panel.
118
If the battery is not sufficiently
charged to work through the
remaining steps of the installation
assistant, an appropriate message
is displayed. In this case, leave the
12.7)
robotic mower in the master
docking station and continue
charging the battery.
Jumping to the next step of the
installation assistant with the OK
button is only possible once the
necessary battery voltage is
available.

9.12 Connecting the perimeter wire

Place the robotic mower (1) within
the mowing area, behind the
docking station (2) as illustrated,
then press the OK button.
Disconnect the power supply unit
plug from the mains, then press the
OK button.
● Remove the cover and open the panel.
( 9.4)
Then press the OK button on the
control panel.
0478 131 9937 B - EN