Installing The Battery; Adjusting The Cutting Height - Viking MI 632 M Manuel D'utilisation

When navigating through the
menus, follow the instructions in the
"Operating instructions" section.
( 11.1)
You can select options, menu items
and buttons using the control pad.
You can open submenus and
confirm selections using the
OK button.
Use the Back button to
leave the active menu or
jump one step back in the
installation assistant.
If errors or faults occur during the
initial installation, a corresponding
message appears on the display.
( 24.)

9.7 Installing the battery

Lithium-ion batteries must be
treated with particular care. VIKING
recommends that you have the
battery installed by a VIKING
specialist dealer. A defective
battery must only be replaced by a
VIKING specialist dealer.
The battery remains permanently
installed in the robotic mower,
removal is only necessary prior to
disposal of the machine. (
● Set the lowest cutting height (level 1).
( 9.8)
● Place the robotic mower on its back on
a suitable surface.
0478 131 9937 B - EN
Insert the battery (C) as shown and allow it
to engage.
20.1)
Fit the cover (F) and tighten the
screws (G). Observe a maximum
tightening torque of 1 - 2 Nm.
● Set the robotic mower on its wheels.

9.8 Adjusting the cutting height

The same cutting height must
always be set for all machines that
work together in an iMow TeaM.
Lowest cutting height:
Level 1 (20 mm)
Highest cutting height:
Level 8 (60 mm)
Press and turn the rotary knob (1). It
engages again when released. The
marking (2) indicates the set cutting
height.
The rotary knob can be removed
upwards from the adjustment
element. This design is
implemented for safety reasons: it
ensures that the machine cannot be
lifted and carried by the rotary knob.
113