Perimeter Wire - Viking MI 632 M Manuel D'utilisation

2 Start signal:
For switching on and off the acoustic
signal that sounds when the mowing
blade is activated.
3 Alarm signal:
For switching on and off the acoustic
signal that sounds when the robotic
mower hits an obstacle.
4 Menu signal:
For switching on and off the acoustic
click that sounds when a menu is
opened and a selection is confirmed with
OK.
5 Keylock:
When the keylock is switched on,
the buttons on the control panel
can only be operated if the Back
button is pressed and held and the
control pad is then pressed forwards.
The keylock is activated 2 minutes after
the last button has been pressed.
11.14 Service
1 Blade change
2 Find wire break
3 Reset settings
1 Blade change:
Installation of a new mowing blade is
confirmed with OK.
If the blade has been in use for
more than 200 hours, the message
"Replace mowing blade" appears.
( 16.4)
2 Find wire break:
If the red LED on the master docking
station flashes, there is a break in the

perimeter wire. (

13.1)
136
● Find wire break ( 16.7)
3 Reset settings:
The robotic mower is reset to the factory
defaults with OK, the installation assistant
is restarted. ( 9.6)
Before pressing the OK button, use
the iMow app to remove the
machine from the iMow TeaM
(release).
● Enter the PIN code after pressing
the OK button.
No PIN code is required in the
safety level "None".
11.15 Dealer area
This area is only for specialist
dealers.
12. Perimeter wire
Before routing the
perimeter wire,
particularly prior to initial
installation, read the
entire section and plan the wire
routing in detail.
Perform initial installation using the
installation assistant. (
Should you require support, your
VIKING specialist dealer will be
pleased to assist you with
preparation of the mowing area and
installation of the perimeter wire.
Check the installation of the perimeter wire
before it is finally secured in place.
( 9.15) Adjustments to the wire routing
are generally necessary in the vicinity of
corridors, confined areas or no-go areas.
Deviations can occur
– if the technical limits of the robotic
mower are reached, for example with
very long corridors or when routing the
perimeter wire in the vicinity of metal
objects or above metal under the lawn
(e.g. water pipes and power supply
lines),
– if the mowing area is structurally altered
for using the robotic mower.
The wire clearances specified in
this Instruction Manual are adapted
to routing of the perimeter wire on
the lawn area.
The perimeter wire can also be
buried up to a depth of 10 cm (e.g.
using a cable-laying machine).
Burial in the ground generally
influences signal reception,
particularly if flagstones or paving
stones are laid over the perimeter
wire. The robotic mower may travel
along at a greater offset to the
perimeter wire, requiring more
space in corridors, confined areas
and when travelling along edges.
Adapt wire routing if necessary.
9.)
0478 131 9937 B - EN