Standard Equipment; Preparing The Machine For; General; Installing Mono Handlebar - Viking ME 339 Manuel D'utilisation

ME 339:
Start motor.

ME 339 C:

Start motor.
ME 339 C:
Stop motor.
36

6. Standard equipment

Item Designation
A Basic unit
B Upper part of grass catcher
box
C Lower part of grass catcher
box
D Pin
• Instruction manual
ME 339 C:
E Washer
F Screw
G Pin
H Clamping piece
I Quick-clamping device
ME 339:
J Flat head bolt
K Cable guide
L Rotary handle
M Cable clip

7. Preparing the machine for

operation
2

7.1 General

Qty.
Risk of injury!
1
Observe the safety instructions in
1
the section "For your safety" (
● Place the machine on level and firm
1
ground when performing all the
operations described.
2
1

7.2 Installing mono handlebar

(ME 339 C)
2
● Locate mono handlebar (1) in
1
working position in handlebar
1 console (2) and hold.
2
● Insert left and right clamping pieces (H)
1
into handlebar console (2) as
illustrated. Fit washer (E) onto
screw (F) and guide screw (F) through
clamping pieces and lower handlebar
2
from the inside to the outside.
1
● Fit washer (E).
2
1
● Insert pin (G) in quick-clamping
device (I) and screw both together onto
screw (F).
● Close quick-clamping device (3).
● Quick-clamping device (3) must be
sufficiently tightened so that it closes
completely and the handlebar is firmly
attached to the handlebar console. If
necessary, release quick-clamping
device again and tighten or loosen
screw (F).
4.).
3
4
0478 121 9917 C - EN