Viking MI 632 M Manuel D'utilisation page 163

Message:
0703 – Battery discharged
see message 0100
Message:
0704 – Battery discharged
see message 0100
Message:
1000 – Rollover
Allowed inclination exceeded
Possible cause:
– Tilt sensor has detected a rollover
Remedy:
– Place the robotic mower on its wheels,
check for damage and confirm the
message with OK
Message:
1010 – iMow raised
Press OK to release
Possible cause:
– Robotic mower has been lifted by the
hood
Remedy:
– Check movement of the hood and
confirm the message with OK
Message:
1030 – Hood fault
Check hood
Then press OK
Possible cause:
– No hood detected
Remedy:
– Check hood (movement, firm seating)
and confirm the message with OK
0478 131 9937 B - EN
Message:
1100 – Control panel
Control panel removed during travelling
Possible cause:
– Control panel has been removed during
automatic operation
Remedy:
– Confirm the message with OK –
automatic operation resumes once the
control panel has been inserted
Message:
1120 – Hood blocked
Check hood
Then press OK
Possible cause:
– Permanent collision detected
Remedy:
– Free the robotic mower, remove the
obstacle or change routing of perimeter
wire if necessary – then confirm the
message with OK
– Check movement of the hood and
confirm the message with OK
Message:
1125 – Remove obstacle
Check wire routing
Possible cause:
– Perimeter wire routed inaccurately
Remedy:
– Checking the routing of the perimeter
wire
Message:
1130 – Stuck
Free iMow
Then press OK
Possible cause:
– Robotic mower has become stuck
– Drive wheels are spinning
Remedy:
– Free the robotic mower, level out the
mowing area or change routing of
perimeter wire if necessary – then
confirm the message with OK
– Clean the drive wheels, if necessary
prevent operation during rain – then
confirm the message with OK (
Message:
1131 – Stuck
see message 1130
Message:
1135 – Outside
Place iMow in mowing area
Possible cause:
– The robotic mower is located outside
the mowing area
Remedy:
– Return the robotic mower to the mowing
area
11.7)
161