ミシンの据付 ( テーブル式 )
Installing the machine head(table-mounted type)
注意 CAUTION
ミシンの据付を行うときは、必ず電源スイッチを切り、電源
プラグをコンセントから抜いてください。
Always turn off the power, unplug the machine and then
authorized technicians are allowed to install the machine.
16
100
テーブルの加工
Fitting table-mounted system
図を参照して、テーブルを加工してください。
(テーブルの厚さは、50mmが基準です。 )
Refer to the figure and alter the table as shown.
(The thickness of the table is 50mm standard).
445
275
525
Fig.1
40
50
図 1