Switching On The Tegrapol With A Tegraforce-3 Installed; Setting The Preparation Parameters - Struers TegraPol 21 Manuel D'instructions

Switching on the TegraPol with
a TegraForce-3 installed
Setting the Preparation
Parameters
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
When a TegraPol has been fitted with a TegraForce-3 and switched
on, the software inside the TegraPol is able to detect the
TegraForce-3, automatically, and informs you of its presence in the
start-up display.
Before starting the preparation process, the disc speed, preparation
time, force and water application need to be specified. This is done
using the control panel software:
If a TegraDoser-5 is mounted on the TegraForce and connected to the
TegraPol, then refer to the TegraDoser-5 Instruction Manual for the correct
procedure for setting the preparation parameters.
If the MAIN MENU is not currently displayed, press Esc

until the MAIN MENU appears.

Use the Arrow buttons



After a TegraForce has been mounted and connected to the
TegraPol there is one more topic on the MAIN MENU, Preparation.
Preparation is selected when the TegraForce is to be used together
with the TegraPol.
If a sample has to be prepared manually, Manual preparation is
selected and the same possibilities as described earlier are
available.
Note!
to select Preparation:

27