Setting Up Tegraforce-5 On Tegrapol - Struers TegraPol 21 Manuel D'instructions

Setting up TegraForce-5 on
TegraPol
32
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
Remove the cap covering the support hole placed on the top of

the TegraPol cabinet.
Support Hole
Fastening
Screws
Remove the two caps covering the fastening screws on the left-

hand side of the TegraPol cabinet by lifting them off with a knife.
Lead the supporting column of TegraForce-5 down into the

support hole in TegraPol.
Supporting
Column
Friction
ring
Fastening
Screws
Turn the column until the cross pin at the end of the column

engages in the slot in the casting of the TegraPol while the
specimen mover is placed over the preparation disc.
Tighten the two fastening screws on the left-hand side of the

TegraPol cabinet and mount the two caps again.
Connect the TegraForce-5 to the back of the TegraPol and to

compressed air.
Switch the TegraPol on and open for the compressed air.
