Disposal; Working With Movipol-3 In The Field; Dangerous Localities; Safety Measures - Struers Movipol-3 Mode D'emploi

Disposal

Working with Movipol-3
in the field

Dangerous Localities

Safety Measures

Dangerous situations

Movipol-3
Instruction Manual
Follow local regulations for disposal of spillage and waste.
Dilution and/or neutralisation are the normally recommended
methods of disposal of the electrolyte.
Certain safety measures must be taken when working with Movipol-3
in the field as some working locations can be dangerous. This is the
case when working in:
 Closed containers, e.g. boilers, tanks and fractionating columns.
 Narrow areas such as shafts, pits, pipes and tunnels.
Working in these above mentioned locations can be dangerous as
poisonous substances can be accumulated and as there can be too
little oxygen in the air.
Consequently it is recommended that tanks or other narrow areas
are not opened or entered without written permission.
Necessary preparations and safety precautions should be mentioned
in the permission and it must be issued by the manager in charge of
safety for the actual process line or plant.
No working process should begin without this permission. The safety
precautions and work processes stated for the place of work should
be followed. In case of doubt regarding the contents of the
authorisation, the issuer should be consulted.
Dangerous situations can occur when working in locations with
choking or poisonous gases. In order to make sure that the air can
be breathed without risk it must be analysed. Electric insulation
defects may also involve a safety risk.
However, safe working procedure may be carried out if adequate
safety precautions are taken before and during the work process.
15