Operating Tegrapol With Tegraforce; Inserting Specimen Holders - Struers TegraPol 21 Manuel D'instructions

Inserting Specimen Holders

26
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual

4. Operating TegraPol with TegraForce-3

The TegraForce-3 can be operated with specimen holders only.
If there isn't sufficient space between TegraForce-3 and the

turntable disc to insert a specimen holder, release the black
handle on the side of TegraForce-3 and swing it to the side until
it is clear of the TegraPol.
Push the black button on the TegraForce-3.

Insert the specimen holder and rotate it until the three pins are

aligned and then push the holder upwards until it locks in
position.
Release the black button on the TegraForce-3 and ensure that

the specimen holder is securely fixed.
If TegraForce-3 was swung to the side, swing it back and align it

correctly over the preparation disc. The specimens should come
close to the edge of the preparation disc. They may extend over
the edge by 2 - 3 mm.
When working with specimen holders make sure that the screws clamping
the specimens do not stick out of the specimen holder.
Use different length of screws for samples with different diameters.
WARNING!
Black button
Pins