Compressed Air Connections; Emptying The Water / Oil Filter - Struers TegraPol 21 Manuel D'instructions

Compressed Air Connections

Emptying the water / oil filter

34
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
The quality of the air in the compressed air system used with this
machine must meet the standards stated in ISO 8573-1. To connect
the TegraForce:

Mount the quick coupling on the pressure hose and secure it with
the hose clamp supplied.

Connect the air hose to the quick coupling and fit the other end
into the compressed air inlet on TegraForce-5.
The air pressure must be between 5 bar (72 psi) and 10 bar (145 psi) and
have a quality specified in ISO 8573-1.
TegraForce is fitted with a water / oil filter that removes excessive
amounts of these substances from the compressed air supply. As a
result of this, it is necessary to empty the filter periodically:

Remove the preparation disc from the work area. Failure to do
this may result in the preparation disc being contaminated by
water and oil particles landing on it.

Locate the release outlet valve on the bottom of the filter glass.

Hold a container under the filter to retain any water released and
press the release valve.

Replace the preparation disc.
IMPORTANT
Release Outlet Valve