Running An Entire Preparation Method - Struers TegraPol 21 Manuel D'instructions

Running an Entire Preparation
Method by Changing
TegraDoser-1
Grinding
Fine grinding
Polishing
TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
As explained above the setting of the ID on the TegraDoser can be
used to run an entire preparation method. This is shown in the
following example:
The first preparation step usually is a grinding step where no

abrasive is used but only water is applied as a lubricant. Here
either the TegraDoser-1 is removed from the TegraForce or
the parameter Water is set to: ON. This also changes the
parameters Speed, Time and Force to what was previously
used in a grinding step.

The second step is the fine grinding step, here a

TegraDoser-1 with the ID 1 is used, containing the DiaPro
suspension for fine grinding on MD-Allegro/Largo.

The third step is the first polishing step, here a TegraDoser-

1 with the ID 2 is used, containing a DiaPro suspension for
polishing.

47