Operating Tegrapol With Tegraforce; Inserting Specimen Mover Plates / Holders; Inserting A Specimen Mover Plate; Inserting A Specimen Holder - Struers TegraPol 11 Manuel D'instructions

Inserting Specimen Mover
Plates / Holders
Inserting a Specimen Mover
Plate

Inserting a Specimen Holder

Switching on the TegraPol with
a TegraForce-1 Installed
TegraPol-11/ -15
TegraForce-1
Instruction Manual

4. Operating TegraPol with TegraForce-1

The TegraForce-1 can be operated with either a specimen mover
plate or a specimen holder.
Unlock the TegraForce-1 using the handle and let it swing into

the upright position.
Remove the three screws securing the specimen mover plate or

slide the specimen holder off the legs.
Put a specimen mover plate in position and secure it with the

three screws.
Insert the correct preparation disc and press TegraForce-1 down

until the lock engages.
Unlock the TegraForce-1 using the handle and let it swing into

the upright position.
Remove the three screws securing the specimen mover plate.

Slide the specimen holder evenly onto the three legs.

Insert the correct preparation disc and press TegraForce-1 down

until the lock engages.
When working with specimen holders make sure that the screws clamping
the specimens do not stick out of the specimen holder.
Use different length of screws for samples with different diameters.
When a TegraPol, which has been fitted with a TegraForce-1, is
switched on, the software inside the TegraPol is able to detect the
TegraForce-1, automatically, and informs you of its presence in the
start-up display.
WARNING!
23