Electrical Connections; Compressed Air Connections - Struers TegraPol 21 Manuel D'instructions

Electrical Connections

Compressed Air Connections

TegraPol-21/ -25/ -31/ -35
TegraForce-3/ -5
Instruction Manual
There is only a single electrical connection between the TegraPol
and the TegraForce. This provides both the 24V power supply to the
TegraForce and a data bus, which enables the TegraPol and
TegraForce to communicate.

Switch off the TegraPol.

Use the single cable attached to the TegraForce and connect it
to the Sample mover connector on the rear of the TegraPol. To
locate this connector, refer to the diagram for the back of the
TegraPol in the section Getting Acquainted with TegraPol.
The quality of the air in the compressed air system used with this
machine must meet the standards stated in ISO 8573-1. To connect
the TegraSystem:

Mount the quick coupling on the pressure hose and secure it with
the hose clamp supplied.

Connect the air hose to the quick coupling and fit the other end
into the compressed air inlet on TegraForce-3.
The air pressure must be between 5 bar (72 psi) and 10 bar (145 psi) and
have a quality specified in ISO 8573-1.
IMPORTANT
23