Struers TegraPol 21 Manuel D'instructions page 319

The TegraPol grinding and polishing machines
The TegraPol grinding and polishing machines are a series of
sturdy, reliable and powerful machines, based on proven tech-
nology and designed for preparation of all types of materialo-
graphic specimens.
- Can be used for manual preparation or be equipped with
specimen mover and dosing system.
- Available in 2 speed versions for standard specimen
preparation and special applications
- Easy and straightforward operation
- TegraPol automatically detects connected units, no
configuration is necessary
- TegraPol power supplies all connected units
- Sturdy and powerful design ensuring years of trouble-
free operation
The 200 mm TegraPol-11 and -15
If you are preparing a limited number of specimens and still
have high requirements to preparation quality, the 200 mm
single disc machines are the perfect solution.
TegraPol-11 is a unit covering all basic requirements with a
speed of 50-300 rpm, whereas TegraPol-15 has a higher speed
range from 40-600 rpm.
Added equipment is automatically detected
As soon as a TegraForce or a TegraDoser is connected, the
TegraPol automatically detects which unit has been connected
and no configuration is required. The operation of the whole
system is carried out on the TegraPol. A large graphical display
ensures easy and straightforward operation.
In the TegraSystem, the TegraPol is the only machine con-
nected to the power mains. All other units are supplied directly
from the TegraPol. The advantage here is of course the limited
need for power outlets at your facilities. The power supply for
all connected equipment is only 24 V.
For TegraPol-11 / -15 a disposable bowl liner is available to facilitate
cleaning of the machine considerably.
Emergency stop
All TegraPol machines are equipped with an emergency stop,
for immediate stopping of all moving parts in case of an
emergency.
Environmentally-friendly recirculation system
A recirculation cooling unit can be connected to the TegraPol
grinding/polishing machines. Controlled from the TegraPol, it
is started and stopped automatically. Polluted debris from the
preparation can be collected safely and the cooling water is
utilised repeatedly. This reduces pollution and waste of water
and eliminates the risk of corrosion of specimens by ordinary
tap water.
The oval opening on
the TegraPol machines
grants easy access when
exchanging consumables.
At the same time it allows to
place the specimen holder
or specimen mover disc in
the best possible position
over the preparation
disc to achieve optimum
preparation results
Recirculation System