Mettler Toledo IND570 Manuel D'installation page 62

26. Inside the enclosure, slide the nut removed in step 12 over the wires. Position the body of the
27. The cable is now ready for connection and grounding.
2.4.5.6.2. External Grounding of the Cable, Harsh Enclosure
1. Disassemble the ground lug (from the Vehicle Scale lightning protection kit) – it includes a
30205319 | 11 | 07/2019
cable gland in the opening, then install and tighten the nut to 40 lb/in (5 Nm).
screw clamp and a mounting bracket. Slide the screw clamp about 8" (200 mm) onto the flat
braided grounding cable (also from the Vehicle Scale lightning protection kit).
Figure 2-53: Grounding Lug and Flat Braided Cable
Figure 2-51: Cables Entering Enclosure
Figure 2-52: Cable Gland Nut Installed
METTLER TOLEDO IND570 Terminal Installation Manual
About 8"/20 cm
of cable
2-29